Print

SB1011 - DBu Switch Extension

 

Click here to download PDF version

Purpose

When using the DBu Digital Belt Pack Transmitter’s programmable switch function, it is common to require a longer switch for easier use. These instructions describe the steps necessary to attach a switch extension.

Tools You Will Need:

 Tools-needed

Procedure

Step 1: Identify the location of the programmable switch on the top control panel.

Step1

Step 2: Apply a very small droplet of adhesive to the tip of a toothpick and then apply it all around inside the cavity of the P1353, Extension part. Wipe away any excess adhesive from the open face of the part if present.

Step2

CAUTION: Use only a small amount of adhesive. Excess will be forced out of the glued interface when applied and may flow onto adjacent switch and/or housing surfaces.

Step 3: Carefully align the P1353 with the switch actuator on the unit and, with the switch moved toward center, push it firmly down over the switch actuator until seated.

Step3

Final Step: Move the switch back and forth a few more times to ensure the switch moves freely.

Final-Step