•  Digital Hybrid Wireless™  Technology*
• Membrane switch control panel with LCD display
• 256 synthesized UHF frequencies
• 100 mW output power (SMa, SMDa) or 250 mW (SMQa)
• Wide input dynamic range
• DSP based pilot-tone signal
• Circulator/Isolator output stage
• Splash-proof, machined aluminum housing
• Non-corrosive, superhard finish

The SM Series family brings Digital Hybrid Wireless® technology to miniature transmitters in several different configurations for essentially any wireless microphone application with a lavaliere microphone. The tiny size of the single battery SMa model makes concealment easy, yet with a full 100 mW output, it does not sacrifice performance. The dual battery SMDa model doubles the battery life of the SMa with the same feature set. The SMQa offers 250 mW RF output power to extend operating range and the unique RM provides hands-free remote control for all three models. Switching power supplies throughout the design allow long battery life with NiMH batteries.

Setup and control is simplified with membrane switches and an LCD interface. Multiple functions are clearly marked on the panel, with on-screen prompts on the LCD as reminders when another switch must be held or the selection is locked out. The innovative servo bias input on the standard 5-pin connector provides a programmable, regulated voltage to accommodate a wide variety of electret microphones. Two bicolor LEDs make adjusting input levels for proper modulation easy and accurate.

The splash-proof housing is machined out of a single block of aluminum, which is then plated with a superhard, non-corrosive coating. The SM Series transmitters are equally at home in theatre, television and film where temperature and environmental extremes require superior performance under the most demanding conditions.

LICENSING INFORMATION:
Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifications not expressly approved could void your authority to operate the equipment. Licensing of wireless microphone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. The user is strongly urged to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies.

SMBCUP Accessory belt clip for attaching the SM with the antenna pointing up.	SMBCDN Accessory belt clip for attaching the SM with the antenna pointing down.	SMDBC Accessory belt clip for attaching the SMD and SMQ transmitters.

Protective leather pouch with belt clip included with SM Series transmitters