C119

Mic clip for M119 Microphone System

C119RA

Mic clip for M119 Microphone System

C140

Mic clip for M140 Microphone System

C140-1

Mic clip (larger cable) for M140 Microphone System

C150

Mic clip for M150 and M152 Microphone Systems

SMKITTA5

Microphone adapter kit with sleeve for SM transmitter. Kit includes instructions, sleeve, tubing and TA5F connector, plus two each 1.5 K Ohm and 3.3 k Ohm resistors.
Download Instructions (PDF).

RK119

Windscreen for M119 Microphone System

RK-142

Windscreen for M140 Microphone System

RK-150

Windscreen for M150 and M152 Microphone Systems

RK51

Replacement windscreen for M121S and the M131S hand held mics.

35690

Strain Relief
For all Lectrosonics Microphone Systems

MCATA5M2-WP

Adapts 2-wire microphones with TA5F connectors wired for Lectrosonics transmitters to MM Series miniature transmitters.

MCATA5M3-WP

Adapts 3-wire microphones with TA5F connectors wired for Lectrosonics transmitters to MM Series miniature transmitters. <br><br>

Click here for combined data sheet (pdf)

MCAXLRLINE-WP

Adapts XLR Line Level microphones to MM Series miniature transmitters. Offers -20 dB attenuation and includes built in isolation capacitor to block DC voltage from transmitter; 37” long.

MCAXLRMIC-WP

Adapts XLR microphones to MM Series miniature transmitters. Includes built in isolation capacitor to block DC voltage from transmitter, 37” long.

MCA-TA5PAD

Two-wire, -10 dB adapter for two wire microphones using TA5F connectors.

MCA-TPOWER

Used with UH200D, UH400 and UH400A plug-on transmitters with T-powered microphones. This adapter converts the UH400's 18 Volt phantom power setting to a TPOWER compatible circuit. It also protects the T-power mic against the 48V phantom power setting in the transmitter while allowing normal operation.

Note
This is not a “universal” adapter and is intended for use with the Lectrosonics UH200D, UH400 and UH400A transmitters only. Both the UH200D and UH400 have been replaced by the UH400A.

MCA5X

Allows lavaliere microphones with 5-pin (TA5F) plugs to be used with the XLR jack on Lectrosonics UH and HM plug-on transmitters. Zener diode protects mic from greater than 6V phantom power on XLR jack.

2 inches long by .75 inches diameter

RATPAC

Right-angle plug kit
Accessory kit for building a single right angle 3-pin or 5-pin TA Series connector for transmitter inputs or SR receiver outputs. Kit includes large and small backshells, two different inserts and strain relief sleeves.